For Fully Qualified Domain Name (FQDN), enter *, which indicates that this send connector applies to messages addressed to any domain. In the Add domain window, make sure SMTP is listed as the Type. Verify that MX record associated with recipient domain is selected, which specifies that the connector uses the domain name system (DNS) to route mail. In the New send connector wizard, specify a name for the send connector and then select Internet for the Type. In the EAC, navigate to Mail flow > Send connectors, and then click Add. Use the EAC to create a send connector for email sent to the Internet Having problems? Ask for help in the Exchange forums. After the installation you can use the steps in this topic to create your outbound connector.įor information about keyboard shortcuts that may apply to the procedures in this topic, see Keyboard shortcuts in the Exchange admin center. See Deploy a new installation of Exchange 2013 if you are beginning your installation. To see what permissions you need, see the 'Send connectors' entry in the Mail flow permissions topic. You need to be assigned permissions before you can perform this procedure or procedures.

What do you need to know before you begin? Interested in scenarios where this procedure is used? See the following topics: The following graphic illustrates mail flow when you create a Send connector to send mail to the Internet. To send mail outside your domain, you need to create a Send connector. By default, Microsoft Exchange Server 2013 doesn't allow you to send mail outside of your domain.

Send email through access 2013